Tii 87 User Manual download pdf

tii 87

141 Rodeo Drive Sealed Subscriber Bridge with POTS Suppression

Edgewood, NY 11717 TII P/N: 92213601

Customer Service/Sales 888-844-4720 Rev C 6/09

INSTALLATION NOTE

BASIC OPERATION

The TII 87 series Sealed Subscriber Bridge with POTS

Suppression (Bridge) allows high speed DSL transmission

between customer and central office while suppressing

POTS. The Bridge is equipped with a test jack and IDC

terminations (see Figure 1). The RJ-11 plug of test

equipment can be inserted into the test jack to assure a

DSL signal is received from the office. This is the only

time the customer is disengaged from the central office.

INSTALLING THE SEALED SUBSCRIBER BRIDGE

• Remove the Bridge from plastic bag and inspect; if

damaged, replace with an undamaged Bridge.

• Hold the Bridge with the cover pivot side on right.

• Lower the pivot side edge inside the designated

installation cavity.

• Engage the right end ledge under the catch. (See

Figure 2)

• Push the left side end down until the latch snaps

closed.

SEALED SUBSCRIBER BRIDGE WIRING

• The Bridge has a pair of wires that are to be

connected to the protector module. The customer has

the option of installing a #10 Master lock around the

customer lock hasp (see Figure 1).

• Do not strip wire insulation from wires to be

terminated to protector.

• Dress terminating wires (to protector) over NID

divider.

• Insert and terminate wires into sealed IDC station

protector (see protector installation note for further

details).

• Open customer security cover on Bridge.

• Lift one Bridge rocker to the open position as shown

(see Figure 1).

• Dress wires around customer security cover.

• Hold the customer DSL pair wires between thumb and

index finger (approx. 1/8” separation between wires).

NOTE: Only use one of the rockers. All rockers are

bridged together.

• Insert wires into wire guides at the same time until

they bottom out.

• While holding wires in wire guides, terminate rocker

with thumb (lower rocker all the way).

• Assure the rocker is in the down position and close

customer security cover.

SIGNAL TESTING

• Open customer security cover.

• Using a portable data test set, insert RJ-11 test plug

into customer test jack (see Figure 3).

• Verify that the portable DSL test set is able to

communicate with central office.

• POTS will not be detected at the test jack.

Figure 2

ure 3

Figure 1

tii 87 1
INSTALLATION NOTE 1

Summary of Contents

Page 1 - INSTALLATION NOTE

tii 87 141 Rodeo Drive S

Comments to this Manuals

No comments

Tii 87 User Manual

Browse online or download User Manual for Equipment Tii 87. Tii 87 User Manual [en] [de] [pl]

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Tii 87