Tii 90-3 User Manual

Browse online or download User Manual for Equipment Tii 90-3. Tii 90-3 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
P/N 92211001 • Rev B5/7/2008
Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.
Model 90-3
SEALED BRIDGING MODULE
Installation Note
Description
1. The TII 90-3 Sealed Bridging Module provides
sealed IDC terminations for connecting six
additional extensions to an existing phone line.
The module can be installed directly into all TII
Network Interface Devices and can be
adapted to fit into a CAC 7600 footprint using
an optional adapter.
Installation
Installing The 90-3 Into A TII
3600/3700/9600/5300 NID
1. Locate the Network Interface Device
2. Unlock the subscriber access cover screw
using a standard screwdriver (Figure 2).
3. Identify the appropriate line position to add the
bridging module.
4. Snap the bridging module to the base as
shown in Figure 3. For installation into a TII
3600/3700/9600/5300 NID, the adapter is not
required.
5. Terminate wire leads (Tip/Ring) from the
bridging module to terminals on the existing
Customer Bridge Module.
6. Do not strip wire insulation from wires to be
terminated to CBM.
7. Lift all CBM rockers to the open position as
shown (see Figure 1).
8. Hold the customer telephone wires between
thumb and index finger (approx. 1/8”
separation between wires).
Figure 2
Figure 3
Adapter
(CAC 7600 Only)
Green (Tip)
Red (Ring)
Figure 1
Telco Shield Screw
Telco Access Screw
Subscriber Access Screw
TII NID Base
Retaining Tab
Page view 0
1 2

Summary of Contents

Page 1 - Installation Note

P/N 92211001 • Rev B• 5/7/2008 Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may b

Page 2 - Figure 4

NOTE: Wires should be aligned to the corresponding holes. Green wire to the “T” (GRN) labeled wire guide and the Red wire to the “R” (RED) labeled w

Comments to this Manuals

No comments