Tii 62 Series User Manual download pdf

TII P/N: _92216901________

141 Rodeo Drive TII 61 / TII 62 Series

Edgewood, NY 11716 Sealed Wire Termination Block

Customer Service/Sales 888-844-4720 11/07 Rev B

INSTALLATION NOTE

1. GENERAL

The TII 61 / TII 62 Series Sealed Wire

Termination Blocks are used where multiple

customer telephone wire terminations are to be

provided. The TII 61 / TII 62 Series provide

connections in the following configurations:

Model Description

TII 61-2-11 4 Rocker IDC Bridge with 2 RJ-11

Cables Out

TII 61-4-11 4 Rocker IDC Bridge with 4 RJ-11

Cables Out

TII 62-4-11 8 Rocker IDC Bridge with 4 RJ-11

Cables Out

TII 62-8-11 4 Rocker IDC Bridge with 8 RJ-11

Cables Out

Installation is accomplished using standard

technician tools. The Insulation Displacement

Contacts (IDC) are achieved using gel sealed

rockers.

IDC Terminations accept 26-22 AWG solid

wire.

2. INSTALLATION

Remove the TII 61 / TII 62 Sealed Wiring

Termination Block and inspect it for damage.

If damaged, obtain another unit.

Align the wire termination block with the

mounting holes on the designated PC board.

Use suitable hardware to attach the block to

the PC board.

Plug in RJ-11 plugs into the corresponding

RJ-11 jacks.

Lift the rocker of the input terminal to the full

up position. DO NOT strip wires. Hold the

customer telephone wire pair to be terminated

between thumb and index finger. Insert wires

into wire guides simultaneously until they

bottom-out. While holding wires in position,

terminate rocker by lowering to the full DOWN

position.

Terminate any additional input or out pairs as

required following the above steps.

To keep wire pairs organized, route them

through the molded wire looms as shown in

Figure 1.

Figure 1

TII 61

TII 62

IDC ROCKER IN

UP POSITION

WIRE GUIDES

IDC ROCKER IN

DOWN/TERMINATED

POSITION

1

Summary of Contents

Page 1 - INSTALLATION NOTE

TII P/N: _92216901________ 141 Rodeo Drive

Related models: 61 Series

Comments to this Manuals

No comments