Tii 83 User Manual download pdf

tii P/N: 92214101

141 Rodeo Drive tii 83

Edgewood, NY 11717 Customer Bridge Module

Toll Free 888.844.4720 With Auto-Jack

RJ-11 Jack

www.tiinettech.com 01/08 Rev B

INSTALLATION NOTE

BASIC OPERATION

Inserting RJ-11 Plug automatically disconnects

customer equipment and connects to central office.

This operation is usually performed during testing of

the telephone line.

By removing RJ-11 plug, customer is automatically

connected to central office. This is the normal

operating mode.

INSTALLING CUSTOMER BRIDGE MODULE

Insert hinge side of module under tab on enclosure.

Dress wires to telco compartment. Pull back retainer

tab, push down module until it snaps in place.

Release retainer tab to hold module firmly in place.

CONNECTING CUSTOMER WIRING

NOTE: The two Tip (Green) and the two Ring (Red)

screws are electrically connected together to provide

increased inside wire connections.

A maximum of 4 telephone wires can be attached to

each wiring bridge screw. Insert wire through

grommet. Strip insulation from wire. Pass wires

behind hinge pin. Connect wire to color

corresponding terminals. (NOTE: If customer wiring

colors do not match Green and Red, inspect the first

jack in premise. Determine which wire colors

connect to Green and Red in jack.)

Connect same wire colors to Green and Red

terminal screws on this module. (Example:

White/Blue stripe to Green; Blue/White to Red).

Wrap each clockwise between a washer on screw.

Insure excess wire ends are wrapped tightly around

screw. Tighten screws snugly. Tuck excess wire in

trough. Additional wires should be coiled and stored

in trough. Perform customary tests. Close and snap

cover securely. (NOTE: Use a Mater

Lock #10 or

equivalent (sold in local stores) when it is desirable

to lock individual covers.)

TESTING PHONE LINE

(CAUTION: INSERT A PLUG INTO TEST JACK

PRIOR TO ANY WIRING CHANGES)

Plug a working phone directly into the test jack.

WAIT ONE MINUTE. Lift receiver. If problem goes

*RJ11 Plug is not required for normal operation

Customer Security Cover

Customer Test Jack (Auto-Jack

)

Customer Lock Hasp

Customer Premise Connections

Customer Wiring Connectors

1 2

INSTALLATION NOTE 1

Summary of Contents

Page 1 - INSTALLATION NOTE

tii P/N: 92214101 141 Rodeo Drive

Page 2

tii P/N: 92214101 away, fault is in customer wiring or equipment. If not, call telephone company. Disconnect plug from jack, close cover.

Comments to this Manuals

No comments

Tii 83 User Manual

Browse online or download User Manual for Equipment Tii 83. Tii 83 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Tii 83