Tii 95-1-00-1 User Manual download pdf

P/N 92208101 • Rev D• 4/30/2008

Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.

Model 95-1-00-1

Customer Bridge Module

With Autojack

Installation Note

Description

1. A Customer Bridge Module (CBM) maintains a

constant direct connection between customer

and central office service provider. The CBM

is equipped with a customer test jack.

Customer can insert the RJ-11 plug from a

working telephone into this test jack to assure

a signal is received from the central office.

This is the only time the customer is

disengaged from the central office.

Installation

Basic Operation

1. Inserting an R-J11 plug automatically

disconnects customer equipment and

connects to the central office. This operation

is usually performed during testing of the

telephone line.

2. By removing the RJ-11 plug, the customer is

automatically connected to the central office.

This is the normal operating mode

Installing CBM

1. Insert hinge side of module under tab on NID

enclosure. Dress wires to telco compartment.

Pull back NID retainer tab, push down module

until it snaps in place. Release retainer tab to

hold module firmly in place.

Wiring

1. A maximum of 4 telephone wires can be

attached to each wiring bridge screw. Insert

wire through grommet. Strip insulation from

wire. Pass wires behind hinge pin. Connect

wire to color corresponding terminals. (NOTE:

If customer wiring colors do not match Green

and Red, inspect the first jack in premise.

Determine which wire colors connect to Green

and Red in jack.)

2. Connect same wire colors to Green and Red

terminal screws in this housing. (Example:

White/Blue stripe to Green; Blue/White stripe

to Red). Wrap each clockwise between a

washer on screw.

Customer Security Cover

Customer Test Jack

Customer Lock

Hasp

Customer Premise

Connections

*RJ11 Plug is not required for normal operation

1 2

Installation Note 1
Testing 2

Summary of Contents

Page 1 - Installation Note

P/N 92208101 • Rev D• 4/30/2008 Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may

Page 2 - Testing

3. Insure excess wire ends are wrapped tightly around screw. Tighten screws snugly. Tuck excess wire in trough. Additional wires should be coile

Comments to this Manuals

No comments

Tii 95-1-00-1 User Manual

Browse online or download User Manual for Equipment Tii 95-1-00-1. Tii 95-1-00-1 User Manual [fr] [de]

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Tii 95-1-00-1